Power Jet-Light 4 x 36 W IP 54
Step
Activity
3
Now pull the illuminant upwards towards the clamp
4
Insert the new illuminant downwards with gentle pressure.
5
Lay the protective cover on the casing. Screw in the 4 protective cover bolts into the
protective cover. Push the seal over the protective cover again.
IMPORTANT: Please note the correct position of the seal between the casing and the
protective cover.
6.3
Replace wiring.
IMPORTANT: Damaged wiring should only be replaced with similar wiring by the manufacturer,
manufacturer's service representative or similar authorized person.
DANGER: Such interventions may mean danger to life through electric attack.
Step
Activity
1
DANGER: Pull the mains plug before opening the work lamp!
Remove the illuminant (See chapter replace illuminant step 1-3)
2
Unscrew the 6 reflector screws. Carefully remove the reflector.
A metal plate is present under the reflector.
3
Unscrew the bolts from the metal plate. Position the metal plate.
Operating Manual
4
5
17
18
18
Pos.
Name
4
Illuminant
5
Clamp
Pos.
Name
17
Reflector screw
18
Reflector
Status: 7201S-07-2007_K