Positioning The Booster Seat - Britax essentials SKYLINE Guide De L'utilisateur

Britax Child Safety, Inc.
Attaching and Removing Lower Connector from Vehicle Lower Anchor
• To attach, remove the lower connector from the storage slot
and firmly push down onto the vehicle lower anchor until a click
is heard�
• To remove, press and hold the red lower connector release
button and pull the connector from the vehicle lower anchor�
14

Positioning the Booster Seat

Use of the lower connectors is not required for proper seat installation� However, the use of lower
connectors, when available, provides additional stability and safety in the event of a crash� If lower
connectors are not used, ensure they are properly stored in the seat base and do not interfere with
the base of the booster seat�
1� Verify the booster seat is compatible with your vehicle� Refer to
pages 22 - 23 for information about compatible seat belts and
head restraints�
a� Push the booster seat back against the vehicle seat back
and ensure that it is positioned correctly so the vehicle head
restraint allows the backrest to lie flat against the vehicle seat
back�
b� Ensure that the base of the booster seat does not hang over
the edge of the vehicle seat�
IMPORTANT: Do not recline the backrest of the booster seat
past the first click�
2� If the vehicle seat back is adjustable, ensure it is in the upright
position before placing the booster seat on the vehicle seat
(see page 9)�
3� Push the lower anchor release button on the child's left side of
the booster seat and pull lower connector to fully extend the
lower connector adjuster strap� Then, repeat on the opposite
side to ensure that all slack has been released from the lower
connector system�
SKYLINE User Guide
15