Mounting The Push Head - Wohler H 420 Mode D'emploi

Getting started
4.3

Mounting the push head

2
1
Fig. 28: Details of the push head
Attaching the quick-change
push-head
Removing the quick-change
push-head
28
1 Rod end piece
2 Cone ring
3 Top section of a push-head
3
ATTENTION!
The M10 female thread of the rod-end piece (1)
must be visible and in perfect condition.
•
Attach the cone ring (2) with the cone area
pointing downwards.
•
Place a star on the top section of the push-
head adapter (3). Then push the top section,
with the star being attached, onto the end
piece of the rod.
•
The clamping plate in the adapter locks the
push-head adapter into place.
•
Grasp the recess at the top of the push-head
with your thumb and index finger and withdraw
the clamping plate.
You can now remove the top section.
NOTE!
It is possible to place two more stars on the star
holder (Abb. 4), so that the user can easily
change the stars while working.