Trix VT 10.5 Serie Mode D'emploi page 13

Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix or
NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• SoftdriveSinus propulsion with a maintenance-free motor
• No automatic system recognition between Selectrix (SX) and
DCC.
• The full range of functions is only available under Trix Sys-
tems and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
• Depending on the length of the train, a stop or braking block
must be relatively long, so that the train will remain stopped
as desired.
All manuals and user guides at all-guides.com
Notes on digital operation:
• The first time the locomotive is used in a digital system (Selectrix
• The operating instructions for your central unit will give you
• The values set at the factory were selected to guarantee the
• This locomotive comes from the factory programmed for the
• Correct programming with the 66920 Mobile Station is possib-
• Information about DCC Operation:
or DCC), the decoder must be set for this digital system. To do
this, the decoder must be programmed once in this digital system
(Example: changing an address).
exact procedures for setting the different parameters.
best possible running characteristics.
digital address „01" (Selectrix) / „03" (DCC) Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
le starting with version number 034.
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC
power operation (CV29 / Bit 2 = 0).
13