Operating From The Remote Control - DeLonghi PINGUINO SMART Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To set this mode:
Touch repeatedly the MODE button until the heating sym-
bol is displayed.
Touch increase > C3 or decrease < C4 keys to adjust the
desired temperature.
Notes:
In this mode, the air ow is selected automatically by the
appliance and cannot be set manually.
When operating in very cold rooms, the appliance defreezes
automatically, momentarily interrupting normal operation. In
this case, " Lt " appears on the display. During this operation, it
is normal for the noise made by the appliance to change.
In this mode, you may have to wait a few minutes before
the appliance starts giving out hot air.
In this mode, the fan may operate for short periods, even
though the set temperature has already been reached.
It may happen that the display shows "HL" alarm. In this
case, empty the internal safety tank following the instruc-
tions in the Section "End of Season operations". At the end,
press again the
button to restore the heating function.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C
or °F.
To change the temperature unit of
measure touch both the increase/de-
crease keys > and < for about 10 sec.

OPERATING FROM THE REMOTE CONTROL

INSERTING OR REPLACING THE BATTERIES
Remove the cover on the rear of the remote control;
Insert or replace the batteries with two new R03 "AAA" 1.5V
batteries, inserting them correctly (see the instructions in-
side the battery compartment);
Replace the cover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in re.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
USING THE REMOTE CONTROL
Point the remote control at the receiver A5 on the air
conditioner. The remote control must be no more than 23
ft (7 metres) away from the appliance (without obstacles
between the remote control and the receiver).
The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
Note: The remote control can be safely stored in the
appropriate compartment A6 (see gure A page 3).
DESCRIPTION OF THE REMOTE CONTROL
D
D1
D2
D4
D1. ON/STAND-BY (on/o ) button
D2. REAL FEEL button
D3. MODE button
D4. Decrease button
D5. Increase button
D6. Air ow button
D7. WiFi button
TURNING THE APPLIANCE ON/OFF
Plug into the outlet.
Press the
button D1 . When turned on, the air condi-
tioner starts operating in the same mode as when it was
turned o .
Press the
button again to switch the appliance o .
Note: Never switch the appliance o by removing the plug.
9
max 23 ft
max 7 m
D3
D5
D6
D7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

El série

Table des Matières