Publicité
Les langues disponibles
Les langues disponibles
Removing a Jammed Brad Nail
(Fig . 9)
a. Remove the battery pack from the tool.
b. Press the magazine release button and
remove the nails from the magazine.
c. Lift the jam release latch and open the jam
release.
d. R emove the jammed nail using a flat
head screwdriver or pliers (not included) if
necessary.
NOTICE: Do not mar/scratch the nail channel
or driver mechanism. The screwdriver should
always slip over the nail when prying.
e. Close the jam release and the latch.
f. Reload the nails and close the magazine.
g. Reattach the battery pack and restart the tool by pressing the trigger switch.
NOTE: Driving the nails too deeply into the material, excess debris, or jammed nails may lead
to a driver blade being stuck at its bottom position.
The driver blade can usually be returned to its operating position by depressing the work contact
element against a scrap piece of wood and squeezing the trigger.
If the tool cycles without driving a nail, the nail channel may be dirty. See 'Cleaning the Nail Chan-
nel' in the 'Maintenance' section of this manual.
Fig. 9
Driver
Mechanism
Jam
Release
Jam
Release
Latch
17
Publicité
