Publicité
Les langues disponibles
Les langues disponibles
Contact Actuation Mode (Fig . 7):
Contact actuation allows very fast repetitive nail placement.
a. Make sure the workpiece is secured before performing any operation.
b. Attach the battery pack.
c. Slide the mode selector switch to the left so that only the symbol "
activate the contact actuation mode.
d. Grip the tool firmly to maintain control.
e. Push the tool against the work surface to depress the workpiece contact.
f. Squeeze and hold the trigger switch to drive a nail.
g. Keep the trigger squeezed, relocate the tool to the next nailing spot and push the tool
against workpiece to drive another nail.
h. Release the trigger when done.
NOTE:
Contact actuation mode still retains the logic of the single sequential actuation mode. This
•
means that the tool can also be operated by depressing the workpiece contact against the
surface and squeezing the trigger switch.
If there is no action for more than 10 seconds after workpiece contact or trigger switch
•
pressed without releasing, firing will be locked unless user releases both workpiece contact
and trigger switch and tries again.
Dry-Fire Lockout
When the magazine has 0-–5 nails remaining, the dry-fire lockout feature will not allow operation.
To resume operation, reload the tool with nails.
LED Work Lights
The two LED work lights, shown in Fig. 8,
will illuminate when the trigger switch or the
workpiece contact is depressed. This provides
additional illumination of the surface of the
workpiece for operation in lower-light areas.
The LED work lights will turn off within approx-
imately 10 seconds after the trigger switch is
released.
16
Fig. 8
LED Work
Lights
" is visible. This will
Publicité
