Antari ICE-101 Mode D'emploi page 7

produce fog output.
Keep pressing the green Manual button to make the machine generate fog at
․
maximum volume. Once Manual button is released, the fog output stops
immediately.
Cleaning your fog machine regularly will help reduce costly part
Maintenance
Do not allow the fog liquid to become contaminated. Always place the lid back on the fog
liquid container and the fog machine liquid tank immediately after filling.
After every 40 hours of continuous operation, it is recommended to run distilled water through
the system to prevent the accumulation of particles in the heating element. The
recommended cleaning steps are as follows:
1. Empty fog fluid from fluid tank. Add distilled water to tank.
2. Plug in and allow machine to finish heating-up process.
3. Run the machine in a well-ventilated area for a few minutes.
4. The cleaning is now completed. Please refill with fog fluids.
5. Run the machine to make sure it can produce fog properly.
Note: All fog machines are prone to clogging due to the thick consistency of the fog fluid and
the high temperature at which it vaporizes. However, a properly maintained fog machine
should provide years of reliable use.
Clean with a dry cloth only.
Store dry.
Performance Notes
. All fog machines develop condensation around the output nozzle. Because this may result
in some moisture accumulation on the surface below the output nozzle, consider this
condensation when installing your unit.
. All fog machines may sputter small amounts of fog occasionally during operation and for a
minute or so after being turned off.
. All fog machines have a recycling period after long bursts when the machine will shut itself
replacement and repair charges.
7