Antari ICE-101 Mode D'emploi page 5

Setup
♦ Remove all packing materials from shipping box. Check that all oam and plastic padding
is removed, especially in the nozzle area.
♦ Place fog machine on a flat surface and remove fog liquid tank cap.
♦ Fill with ANTARI Fog Liquid or other high-quality water-based fog fluid. Any other types of
fluid can damage the unit. When filled, place cap back on liquid tank.
♦ Fill the chamber with regular ice cubes or dry ice. The chamber can hold as much as 8 kg
ice cubes.
♦ When the chamber is filled, gently put the cover back. Tighten the cover with appropriate
force only.
♦ Firmly attach the included tube to the drainage outtake. Place the end of the tube to a
container.
♦ Firmly attach the remote control cable to the proper input on the rear of the machine.
Operation
♦ Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear
of unit to "ON" position. Warm-up is complete when green lamp lights up on remote unit.
♦ To emit fog, press the appropriate button on the remote for the desired length of time.
♦ The remote unit's lamp will cycle on and off as the machine re-heats to the proper
operating temperature.
♦ DANGER OF LEAKAGE! The water tank must regularly be drained.
♦ For further information on operating your ANTARI Fog Machine, see the section titled,
"Remote Control Operation".
If your model includes a mounting bracket designed for overhead installation, it may be
installed at floor level or suspended overhead. If the unit is to be mounted using the
bracket, it is important that the fog does not shoot directly at any one's face. Whatever
5