Hama 00136219 Mode D'emploi page 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep
these instructions in a safe place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific
hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
• PG-300 DCF wireless wall clock
• 1 AA battery
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and overheating, and only use it in a dry
environment.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not place the product near interference fields, metal frames, computers, TVs, etc.
Electronic devices and window frames can negatively affect the product's functionality.
• Do not modify the product in any way. Doing so voids the warranty
• Keep the packaging material out of the reach of children due to the risk of suffocation
• Dispose of packaging material immediately according to locally applicable regulations
Warning – Batteries
• Immediately remove and dispose of dead batteries from the product.
• Only use batteries (or rechargeable batteries) that match the specified type.
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries accordingly. Failure to do so could result
in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep them away from
uncoated metal objects.
4. Getting Started
4.1 Inserting the battery
• Remove the battery that was already inserted; remove the protective film if necessary as
well as the contact interrupter, and then re-insert the battery with the correct polarity.
The clock is ready for operation.
4.2 Replacing the battery
• Remove and dispose of any used batteries. Insert a new battery (AA). Ensure that the
polarity of the battery corresponds to the symbols in the battery compartment.
5. Installation
• You can mount the PG 300 DCF wireless wall clock on a wall using the opening on
the back.
Warning – Mounting Note:
• Before mounting the clock, ensure that the chosen wall is suitable for the weight to
be mounted, and make sure that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
• Purchase special fastening materials from specialised dealers.
2
6. Operation
6.1 Automatic time setting
• Once the battery is inserted properly, the clock will automatically be set to 12:00 pm and
its reception will be activated. As soon as the DCF signal was received and processed
(approx. 3 to 15 minutes), the correct time is displayed automatically. Do not move the
clock during this process.
• If the clock has not correctly set itself after 15 minutes, there is a problem with the
reception or with the selected location.
• Repeat the setting process at another location. First, remove the battery for about 1
minute and then insert it in the battery compartment again.
6.2 Setting the time manually
M.SET button:
• Hold down the M.SET button until the appropriate time appears.
• As soon as the clock receives the DCF signal, it will reset the time.
REC button:
• Press and hold the REC button on the rear side for 3 seconds. The seconds hand moves
to the 12 position. It then tries to receive the time signal and reset itself accordingly.
• If the clock finds a DCF signal, it adjusts itself automatically. If no signal is received
within 16 minutes, the clock reverts to the original time.
RESET button:
• Press and hold the RESET button on the rear side for 3 seconds. The clock sets itself to
position 12. It then tries to receive the time signal and reset itself accordingly.
Note
Note that electronic devices such as TVs, PCs, etc. can interfere with reception when
located within up to two metres of the product.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive
cleaning agents.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting
from improper installation/mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
10. Technical Data
Power supply
11. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and 2006/66/
EU in the national legal system, the following applies: Electric and electronic
devices as well as batteries must not be disposed of with household waste.
Consumers are obliged by law to return electrical and electronic devices as
well as batteries at the end of their service lives to the public collecting points
set up for this purpose or point of sale. Details to this are defined by the national law of
the respective country. This symbol on the product, the instruction manual or the package
indicates that a product is subject to these regulations. By recycling, reusing the materials
or other forms of utilising old devices/Batteries, you are making an important contribution
to protecting our environment.
12. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio equipment type
[00136219, 00136220, 00136221] is in compliance with Directive 2014/53/
EU. The full text of the EU declaration of conformity is available at the
following internet address:
www.hama.com -> 00136219, 00136220, 00136221 -> Downloads.
PG-300 DCF wireless wall clock
1.5 V
1 AA battery