Before You Start Playing; Installing The Music Stand; Connect The Supplied Adapter; Connecting Headphones - Roland ep 880 Mode D'emploi

Before You Start Playing

Installing the music stand

Assemble the music stand as shown in the diagram.
When moving the ep 880, be sure to remove the music
stand as a safety precaution.
Connect the supplied
adapter
Connect the small end of the adapter cable to the
ep 880's DC IN jack, and the other end to a suitable
wall outlet.
Be sure to use the supplied adapter.
To prevent malfunction and/or damage to the speak-
NOTE
ers or other devices, always turn down the volume
and switch off all devices before making any connec-
tions.
10

Connecting Headphones

The ep 880 has two jacks for plugging in headphones. This
allows two people to listen through headphones
simultaneously, making it very useful for lessons and
when performing piano pieces for four hands.
Additionally, this allows you to play without having to
worry about bothering others around you, even at night.
Plug the headphones into the Phones jack located at
the front left of the piano.
When headphones are connected, the [
(Headphones)] indicator (p. 8) lights up, and sounds
stop playing from the speakers of the ep 880. The
headphone volume is adjusted by the [VOLUME]
knob (p. 11).
Phones jack x 2
Use stereo headphones.
NOTE
Some notes on using headphones
• If both headphone sockets are used simultaneously,
some distortion may be audible with certain
headphone types. In that case, slightly reduce the
VOLUME setting until the distortion disappears.
• To prevent damage to the cord, handle the
headphones only by the headset or the plug.
• Connecting the headphones when the volume of
connected equipment is turned up may result in
damage to the headphones. Lower the volume on the
ep 880 before plugging in the headphones.
• Listening at excessively high volume levels will not
only damage the headphones, but may also cause
hearing loss. Use the headphones at a moderate
volume level.