Before You Start Playing; Connecting The Pedal Cable; Connecting The Power Cord; Opening/Closing The Lid - Roland HP103e Mode D'emploi

HP103e/102e – Before You Start Playing

Before You Start Playing

Connecting the Pedal Cable

Connect the pedal cable to the Pedal jack on the
bottom panel of the instrument, at the rear.
fig.00-01

Connecting the Power Cord

1. Insert the included power cord into the AC inlet
on the bottom panel of the instrument, at the rear.
2. Plug the power cord into a power outlet.
Be sure to use the supplied power cord.
NOTE

Opening/Closing the Lid

To open the lid, use both hands to lift it lightly,
and slide it away from yourself.
To close the lid, pull it gently toward yourself, and
lower it softly after it has been fully extended.
fig.00-05
When opening and closing the lid, be careful not to let
your fingers get caught. If small children will be using the
HP103e/102e, adult supervision should be provided.
If you need to move the piano, make sure the lid is
NOTE
closed first to prevent accidents.
8

Setting up the Music Rest

Set up the music rest as shown in the figure below.
Fold the three supporting feet at the back of the rest and
check whether the stand is held in place.
Before moving the HP103e/102e, be sure to lower the
music stand as a safety precaution.
I Using the Music Holders
You can use the holders to hold pages in place. When not
using the holders, leave them folded down.
fig.mu_stand4