Turning The Power On And Off; Adjusting The Sound's Volume And Brilliance; Connecting Footswitches; Hold Function - Roland ep 880 Mode D'emploi

Turning the Power On and
Off
Once the connections have been completed, turn on power
to your various devices in the order specified. By turning
on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other
devices.
To turn the power on, turn the [VOLUME] knob all
the way down, and then press the [Power] switch.
The power will turn on. After a few seconds, you will
be able to play the keyboard to produce sound.
Use the [VOLUME] knob to adjust the volume.
This unit is equipped with a protection circuit. A
NOTE
brief interval (a few seconds) after power up is
required before the unit will operate normally.
To turn the power off, turn the [VOLUME] knob all
the way to the left, and press the [Power] switch.
The Power indicator at the left front of the ep 880 will
go dark, and the power will be turned off.
If you need to turn off the power completely, first turn
off the Power switch, then unplug the power cord
from the power outlet. Refer to "Power Supply" (p. 6).
Adjusting the Sound's
Volume and Brilliance
Turn the [VOLUME] knob to adjust the overall
volume.
Press the [BRILLIANCE] button to adjust the
brightness of the sound.
Select one of the three available settings to obtain the
desired brilliance.
Off Medium
Mellow
Red
Green Bright

Connecting footswitches

The ep 880 provides two pedal sockets: HOLD and SOFT/
HOLD 2. Here is how you can use these sockets:
DP-2, DP-6, or BOSS
FS-5U (optional)
–OR–
Supplied DP-8 damper pedal

Hold function

By connecting the supplied damper pedal to the HOLD
socket, you can hold (sustain) the notes you are playing on
the ep 880's keyboard.
1.
Set the ep 880's volume to the lowest value.
2.
Connect the supplied DP-8 damper pedal to the
HOLD socket.
3.
Play a few notes on the keyboard while pressing the
supplied DP-8 damper pedal.
The notes you play will be sustained much longer
than without using the pedal.
4.
Release the damper pedal to switch off the sustained
notes.
Using a second footswitch
The SOFT/HOLD 2 socket allows you to connect an
optional DP-2, DP-6, or BOSS FS-5U footswitch. When not
in TWIN PIANO mode, this footswitch functions as soft
pedal to reduce the volume and brightness of the notes
you play.
In TWIN PIANO mode (p. 16), however, it acts as damper
pedal for the left section.
Optional DP-8 damper pedal
–OR–
DP-2, DP-6, or BOSS
FS-5U (optional)
11