Publicité
Les langues disponibles
Les langues disponibles
Irregular Cabinet and Countertop Heights
Countertops such as ceramic tile tops cause cabinet and
countertop to be higher than 36 inches. Follow instructions
below when countertop is higher than 36 inches.
1. Raise leveling legs to maximum height.
2. Measure from floor to rangetop. If measurement is
less than height of countertop, floor must be
shimmed.
3. Shim floor using a piece of plywood same size as
range opening. Secure plywood to floor. Plywood
must be as secure as original flooring.
4. Install anti-tip bracket and slide range into place.
Line Voltage Requirements
Line voltage must not exceed rated voltage. See rating plate
attached to range for kilowatt rating. Line voltage less than
rated voltage will result in slow heating. Wiring system must
conform to C.S.A. standards and Canadian Electrical Code.
Installation must conform to all local, municipal and state
building codes, and local utility regulations. Range must
be connected only to a supply circuit as specified on rating
plate wiring diagram of range.
Range requires 4 wires, 120/240 Volts, 60 Hertz A.C.
House wiring and fusing must comply with local wiring
codes. If no codes apply, wire according to Canadian
Electrical Codes-latest edition.
Power Supply Location
Shaded area show range clearance for electrical
connection.
A
B
C
A—3 inches
B—6 inches
C—6 inches
1
D—30
/
inches minimum
8
E—3 inches
Power Supply Location
All manuals and user guides at all-guides.com
A
E
C
D
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1
1. Measure 3
/
inches from back wall on right and left
2
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
1
line drawn 3
/
inches from back wall and side of
2
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
Anti-tip Bracket Installation
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position, remove range storage
drawer or lower panel and confirm anti-tip bracket is
engaged with range leveling leg.
6
or
3 1/2"
3
/
-inch drill bit.
32
3
/
-inch masonry drill
16
Publicité
