Kärcher BDP 50/1500 C Mode D'emploi page 14

Swivel the handle to the front
With the 230V/60Hz variant the handle can
be swivelled to the front for transport and
storage.
 Pull the lever for level adjustment.
 Swivel the handle to the front.
 Release the lever for level adjustment.
Transport
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
 Remove the pad from the device.
CAUTION
Risk of personal injury or damage! Consider
the weight of the appliance when storing it.
Fault
Appliance does not start, indicator
lamp "main power" does not illumi-
nate.
Appliance does not start, indicator
lamp "main power" is illuminated.
Appliance vibrates strongly
Pad does not turn
14
Storage
 This appliance must only be stored in
interior rooms.
 Select the storage site for the appliance
taking into consideration the permissi-
ble total weight of the appliance in order
not to impact its stability.
 Remove the pad from the device.
Care and maintenance
DANGER
Risk of injury. Pull the plug from the mains be-
fore carrying out any tasks on the appliance.
 Check the mains connection cable for
damages. Replace the defective mains
cable.
 Check filled level of the filter bag; re-
place, if required.
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
DANGER
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Remedy
Check fuse in the building, main cables, plugs and
socket. If the fuse in the building is tripped several
times, contact customer service.
Properly operate the release, see "switching on the
appliance".
Put the handle into the working position. With the han-
dle in the upright position, the appliance cannot be
started.
Check for correct connection of the connector in the
control line.
Check pad attachment
Clean the pad
Replacing the pad
Check if foreign bodies are blocking the pad; remove
the foreign bodies if required.
– 5
EN
Maintenance contract
Troubleshooting