Télécharger Imprimer la page

Kärcher BDP 50/1500 C Mode D'emploi page 12

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Assembly
1
2
1 Nut
2 Disc
3 Handle
4 Appliance base
5 Hexagonal screw
6 Female connector control line
7 Male connector control line
 Unpack the appliance.
 Remove the cable ties from the bottom
end of the handle.
NOTICE
Ensure that the toothed wheel does not fall
out of the opening.
 Hold the handle over the appliance
base upright and with the cable hook to
the back.
 Insert the bottom end of the handle be-
tween the two tabs of the appliance base.
 Align the borings.
 Connect the handle and the appliance
base using the 3 enclosed screws, 6
washers and 3 nuts as shown in the il-
lustration above.
 Tighten the screws using the enclosed
open end wrench.
 Insert the plug of the control line into the
female connector of the control line.
12
3 4 2
5
6
7
– 3
EN
Before Startup
Inserting a filter bag
 Disconnect the mains plug from the socket.
 Pull the lever for level adjustment and
bring the handle in a vertical position.
 Tilt the appliance backward and store it
on the handle.
1
1 Filter bag
2 Cover
3 Connection neck, vacuum apron
 Slide the cover downward/to the rear
and remove it.
 Insert the filter bag into the appliance
and place over the connection neck of
the vacuum apron.
 Replace cover.
Attach the pad
CAUTION
Risk of damage!
Do not store the appliance with inserted
pad. Always remove the pad after every
use.
 Disconnect the mains plug from the
socket.
 Pull the lever for level adjustment and
bring the handle in a vertical position.
 Tilt the appliance backward and store it
on the handle.
2
3

Publicité

loading