Publicité
Removing the right speaker
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
3. Remove the
WWAN card
4. Remove the battery.
About this task
The following images indicate the location of the right speaker and provide a visual representation of the removal procedure.
Steps
1. Peel the tape that secures the right speaker cable to the chassis.
2. Disconnect the right speaker cable from connector on the system board.
3. Remove the two (M1.6x1.8) screws that secure the right speaker in place.
4. Peel the tape that secures the right speaker to the chassis.
5. Lift the right speaker off the chassis.
Installing the right speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
38
Retrait et installation de composants
Before working inside your
if applicable.
computer.
Before working inside your
Publicité
