EUROM 334890 Manuel D'utilisation page 32

Description
The infrared patio heater consists of 3 parts:
- heater with an electric cable, plug and mounting bracket;
- wall support with attachment materials;
- remote control.
After opening the packaging, check immediately whether the delivered contents are
complete and in perfect order. Contact your supplier if the product delivered is
incomplete or has faults. Do not use the infrared patio heater if it is defective. Save
the original packaging during the lifespan of the infrared patio heater in a safe
place, out of reach of children. Use the packaging for storage and transport.
Dispose of the packaging only after the lifespan of the infrared patio heater has
expired.
Installing and attaching
 The wall on which the appliance will be mounted and the ceiling above it must be
made of non-flammable material or material that is hardly flammable. In any
case, it must be able to withstand a temperature of at least 150°C without
scorching, melting, warping or catching flames. Check regularly whether the wall
and ceiling are not overheated; this can be dangerous!
 Prior to mounting, minimal safe mounting distances and tilting angles must be
observed (as shown in the illustrations below).
 When mounting the heater on a wall (both in horizontal and vertical position),
always make sure that the lowest heat point of the protective grid is at least 180
cm from the ground. This means that if you want to use the infrared heater in
either horizontal or vertical position, the holes that you drill for the wall bracket
must be at a distance of at least 210 cm (for the Golden Slim 1500) and 220 cm
(for the Golden Slim 2000).
32