EUROM 334890 Manuel D'utilisation page 27

The Golden Slim infrared heater is equipped with a rotatable wall bracket so that it
can be used horizontally or vertically. This deserves special attention when
installing the appliance, because you must take into account the minimal distances
from the wall, ceiling and ground in all the optional positions:
The housing, especially the front side of the appliance, becomes extremely hot. For
safety reasons, when mounting the Golden Slim infrared heater on a wall (both in
horizontal and vertical position), always make sure that the lowest heat point of the
protective grid is at least 180 cm from the ground.
This means that if you want to use the infrared heater in both horizontal and
vertical position, the holes that you drill for the wall bracket must be at a distance
of at least 210 cm (for the Golden Slim 1500) and 220 cm (for the Golden Slim
2000). Make sure that – when mounting the infrared heater – the distance to the
ceiling must be at least 25 cm under all circumstances – both for vertical and
horizontal use. The minimal distance to any side walls is 50 cm.
Make sure that the infrared heater is always directed downwards and never towards
the ceiling to prevent overheating of the ceiling.
Production description
This infrared patio heater is energy-efficient, environmentally-friendly and is very
suitable for outdoor use. In addition, this infrared heater has a high degree of
water-tightness (IP65, completely dust & spray-water tight).
Use the infrared heater only for what it was designed to do: heating a patio or an
area with a canopy.
The infrared patio heater has a separate electric part with a receiving point for a
remote control and an On/Off switch at the rear side.
Carefully read the safety regulations, the instructions for mounting and operating
before you install or operate the infrared patio heater.
Any change made to the infrared patio heater can have consequences for safety
and the warranty.
27