Suzuki 57100-27810-000 Instructions D'installation page 11

Use an appropriate grip cement, and dry well the applied part, then
check if it is securely adhered. If it has not completely dried or if
a different cement is used, there is a risk that the grip may slip off
while riding. Verify that the grip is securely mounted to the handle-
bars before operating the motorcycle.
7. Install the handlebar balancer
and balancer screw, and tighten
it to the specified torque.
Screw : 5.5N . m
(0.55 kgf-m, 4.0 lbf-ft)
Installation of Grip Heater
Switch
1. Install the Grip Heater Switch
② to the Switch Bracket ⑧
with the Screws ③ as shown
and tighten it to the specified
torque.
Screw : 0.4N . m
(0.04 kgf-m, 0.3 lbf-ft)
WARNING
Handlebar balancer
Balancer screw
③
GENUINE SUZUKI ACCESSORIES
11 /20
⑧
②