Chiller Menu Procedures; Checking Chiller/Heat Pump Status - AERMEC VMF-E5 Manuel D'utilisation

• Checking chiller/heat pump status:

CHILLER
+12.0 C
+10.0 c
ESC
D
ESC SET
CHILLER
+12.0 C
+10.0 c
4
50
GB
6795770_02

CHILLER menu procedures

C
E
3
The fi rst window of the CHILLER menu allows the user to
monitor the status and settings of the chiller or heat pump
unit installed in the system; the information displayed in this
window is:
- Functioning mode (
is currently set on the chiller/heat pump; the symbols which
A
may be viewed:
- (chiller mode = WINTER);
B
- (chiller mode = SUMMER);
- Chiller/heat pump status (
situation of the chiller/heat pump; the symbols which may be
viewed:
- with fi xed spiral (it means that the compressor of the
unit is stopped);
- with moving spiral (it means that the compressor of the
unit is active);
- (this means that the unit is in the defrosting phase);
!
- (this means that the unit is broken or it is not connected
to the VMF system);
- Water outlet temperature (
of the water currently produced by the chiller/heat pump;
- Current work setting (
currently used by the chiller/heat pump;
From the CHILLER menu it is possible to:
(1) Enable or disable the chiller/heat pump:
by pressing the C key, the chiller/heat pump can be enabled
or disabled; the icons above the
these two states are:
1
- (represents the ENABLED status);
- (represents the DISABLED status);
2
If the unit is ENABLED, it will be managed based on the
settings supplied by its work set point and by the eventual
hourly program associated; if on the other hand this unit is
DISABLED, it will be forced to remain in the OFF status until it
is enabled once again;
(2) Pass on to the next window:
To pass on to the next window of the chiller menu, press the
A B
or key;
(3) Exit this window:
Press the D key to return to the selection of the menus;
(4) Enter the chronothermostat submenu:
If the system does not have fan coils or other types of
terminals (radiating fl oors, radiators, etc.) it is possible to
activate the chronothermostat function. This function can be
set by means of the relative menu, which is accessed by
pressing the E key; if the system is provided with fan coils,
this key cannot be used.
1 ): Indicates which functioning mode
2 ): Indicates the current
3 ): indicates the temperature
4 ): indicates the work setting
C key which represent