Setting The Temperature For Domestic Hot Water Storage Tank; Setting Domestic Hot Water Temperature On/Off Band - AERMEC VMF-E5 Manuel D'utilisation

• Setting the temperature for domestic hot water storage tank:

Temperatura acqua
50.0
ESC
D

• Setting domestic hot water temperature ON/OFF band:

Banda On/Off
05.0
ESC
D
48
GB
6795770_02
A
c
B
C
A
c
B
C
In order to provide the production of domestic hot water in the
system, use a storage tank supplied with an exchange coil
(the dimensioning of the storage tank, coil, heat pump and
any integrative sources is the responsibility of the designer);
the system will demand the production of domestic hot
water if the temperature inside the domestic storage tank
drops below a certain value; to set this temperature value is
necessary to:
(1) Enter modifi cation mode by pressing the
key has been pressed, the numbers which represent the set
temperature will begin to fl ash;
(2) Press the A key to increase the selected value or else
press the B key to decrease it;
(3) Press the C key to confi rm the value entered; once
this key has been pressed, the set numbers will have quit
fl ashing, thus indicating that the modifi cation procedure has
concluded.
After the work setting has been entered it will be possible to:
- Pass on to the following window by pressing the
- Go back to the previous window by pressing the
- Press the D key to return to the selection of the menus.
A storage tank is used to produce domestic hot water. Bit by bit as
the water stored is used up, the internal temperature drops until the
point where the system requires the intervention of the heat pump
to raise the temperature. This point is called the "ON temperature".
When the heat pump has started to heat the water, the temperature
inside the storage tank raises until it reaches the "OFF temperature",
thus switching the heat pump off. The ON and OFF values are
calculated automatically by the system by subtracting and adding
the values set in this screen to the domestic water work setting in the
previous screen. To set the ON/OFF band is necessary to:
(1) Enter modifi cation mode by pressing the
has been pressed, the numbers which represent the set temperature
will begin to fl ash;
A
(2) Press the key to increase the selected value or else press the
B key to decrease it;
(3) Press the C key to confi rm the value entered; once this key
has been pressed, the set numbers will have quit fl ashing, thus
indicating that the modifi cation procedure has concluded;
After the work setting has been entered it will be possible to:
- Pass on to the following window by pressing the
- Go back to the previous window by pressing the
- Press the D key to return to the selection of the menus.
C
key; after this
A key;
B
key;
C key; after this key
A key;
B key;