Sage the Barista Touch Impress Guide Utilisateur page 12

• Grinding will automatically stop.
INTELLIGENT BREW SETUP
Intelligent Brew Setup is a feature that helps
achieve a good coffee extraction range by
assisting the dial-in process of the grinder.
When successfully completed, you can enjoy
a balanced coffee shot.
From this point, further adjust grind size and
experiment to suit your style.
It is recommended using this feature whenever
you change beans, or the too fast or too slow
notifications are shown on screen.
Find the Intelligent Brew Setup in the Settings
menu under Drinks Settings.
MANUAL GRIND PURGE
For best coffee results, if the machine has not
been used for a while it is recommended to
purge any stale beans that have been ground
and left in the grinder chute.
To purge; tap and hold the grind button for
2 seconds, and run for around 5 seconds.
To stop; press the stop button. Grind purge
will stop automatically after 30 seconds if stop
button is not pressed.
12
ASSISTED TAMPING
• When grind cycle is completed, the machine
is ready to tamp.
ASSISTED TAMPING
• When grind cycle is completed, the machine is
ready to tamp.
• Push the lever downwards to the end position.
This will tamp the coffee grinds in the portafilter
using a consistent amount of tamp force. Pushing
the lever slowly and consistently will help to
improve the puck appearance.
• Release the lever slowly upwards to the home
position after tamping.
• Repeat the tamping action as above twice.
NOTE
Screen will indicate if tamp or dose is low, ideal
or high.
HOW TO CORRECT AN
UNDER OR OVER DOSE?
An under or over dose can occur when fresh
beans are added to the hopper; when coffee
beans age; a different type of coffee bean is
used or if a change is made to the grind size.
What to do when dose level is
below the ideal middle bar?
• When dose is below the ideal middle bar, the
machine will indicate and calculate 'A Bit More'.
Tap the portafilter image on screen to add a bit
more and follow screen prompts and complete
a tamp for an updated dose level reading.
• When ideal dose level is reached, the machine
will automatically update the auto dose time for
the next cycle.
What to do when dose level is above
the ideal middle bar?
• When dose is above the ideal middle bar, remove
the portafilter from the cradle.
• Use the Razor Trimming Tool. (refer to Trimming
the Dose section).