GGP ITALY MC 534 TR Manuel D'utilisation page 42

EN
CHANGING BLADES
To replace the blade, undo the screw (fig. 19, 20).
Fit the new blade so that the stamped logo is
turned up facing the blade holder (not facing the
grass).
Reinstall as illustrated. Tighten the screw properly.
Tightening torque 40 Nm.
When replacing the blade, the blade screw should
also be replaced.
Each intervention on the blade is best if conducted
at a specialised Centre that has the most appropri-
ate tools.
Only blades with the following codes must be used
on this machine:
81004138/0 (fig. 19)
81004139/0 (fig. 20)
Blades must always be marked
uct evolution, the above mentioned blade may be
replaced in time by others, with similar inter-
changeable and operating safety characteristics.
STORAGE
The same petrol must not remain in the tank for
more than one month.
Thoroughly clean the mower and store it indoors in
a dry place.
SERVICING
Genuine spare parts are supplied by service work-
shops and by many dealers.
We recommend that you take the machine to an
authorised service station for annual servicing,
maintenance and inspection of safety equipment.
For service and spare parts, please contact the
dealer where the machine was purchased.
All manuals and user guides at all-guides.com
ENGLISH
. Given the prod-
36
EN