Arregui Print Mode D'emploi page 8

Thank you for purchasing this safe. We advise you to read the
instructions before you install and use the safe to prevent its
improper use from making the guarantee void.
1. CHARACTERISTICS OF THE PRODUCT
FRONT DIAGRAM OF THE SAFE
1. Knob.
2. Plastic cover - Emergency lock and socket for external
power supply for battery.
3. Numeric keypad.
4. Fingerprint reader.
1
2
2. FIRST TIME THE SAFE IS OPENED AND
INSTALLATION OF THE BATTERIES
• Remove the small plastic cover on the front panel by pres-
sing the left side of the cover inward
• Insert the key into the key hole and turn it counter-clockwise
direction and keep it in that position.
• Turn the doorknob clockwise direction to open the safe.
• In order to function, the safe needs 4 x 1.5 V alkaline batte-
ries that are placed at the back of the door.
• Open the cover of the battery holder and place the batteries
taking into consideration their polarity.
To ensure the system has been successfully activated, do the
following:
• Press and hold the "reset" button, on the left of the back of
the door next to the hinges, the green LED will flash approx.
15 times and at the end you will hear a long beep.
3. CONFIGURE AND DELETE FINGERPRINT
a) Configure fingerprint
• Press the "reset" button on the left of the back of the door.
• When the fingerprint reader lights up, place your finger on
the reader and you will hear two short beeps and one long
long beep.
• Up to 32 fingerprints can be registered.
b) Delete all fingerprints
• Press and hold the "reset" button on the left of the back
of the door next to the hinges, the green LED will flash
approx. 15 times and at the end you will hear a long beep,
to indicate all fingerprints have been deleted.
All manuals and user guides at all-guides.com
IMPORTANT NOTE: each time you press the reset button,
the user code reverts to factory code "1234". Change it
immediately.
Press and hold the digit "1" until the green LED turns on.
Enter the code above (the default code is "1234") and press
the button .
When you hear a long beep, enter the new code (3 to 8 digits)
and press . To confirm, repeat the operation. Enter the code
again and press .
If the operation has been successful, you will hear a long beep
at the end and the LED will turn off.
4
3
a) Fingerprint access
Note: if the fingerprint system has not registered any
fingerprints, the door cannot be opened using this system,
configure the prints.
b) Code access
If you have forgotten the code or your fingerprint does not
work or the box runs out of batteries, use the emergency
key to open the safe (see point 2) and then reset code and
fingerprint access.
When the battery is running low, the red light will flash, which
means you must change the batteries.
Close the door and turn the knob counter-clockwise.
4. PROGRAMMING THE USER CODE
5. OPENING THE SAFE
• Press .
• When the fingerprint reader lights up, place finger on it.
• You will hear a beep and the green LED will light up to
indicate the door can be opened, turn the knob in a
clockwise direction and open the door.
• If the operation has not been carried out correctly, the red
and green LEDs will light up at same time and you will
hear 3 beeps.
• Enter your access code and press .
• You will hear a beep and the green LED will light up to
indicate that the door can be opened, turn the knob in a
clockwise direction and open the door.
• If the operation has not been carried out correctly, the red
and green LEDs will light up at same time and you will
hear 3 beeps.
6. EMERGENCY OPENING
7. CLOSING
En