THOMSON THI3PLANCHA Manuel D'utilisation page 26

INSTALLATION
Cut a hole in the worktop of the dimension shown in the diagram below. A
minimum of 50 mm space should be left around the hole. The worktop should
be at least 30 mm thick and made of heat-resistant material.
Note: The safety distance between the sides of the hob and the inner
surfaces of the worktop should be at least 3 mm.
Min. 50mm
It is essential that the induction hob is well ventilated and that the air intake
and exit are not blocked.
Make sure the hob is correctly installed as shown.
B Min. 50 mm
C
Min. 20 mm
Air intake
Pan
Magnetic circuit
Plate
Induction coil
Induced current
Air exit 5mm
E
25
Min. 3mm
Min. 30mm