Publicité
Les langues disponibles
Les langues disponibles
6. Reinstall the fuel tank cap.
7. Repeat steps 1,2,5,6 to empty the oil tank.
ANGLE TRANSMISSION(Fig.22)
Lubricate with lithium-based grease.
Remove the screw (1) and put in the grease, turning the shaft manually until
grease emerges, then replace the screw (1).
REPAIRS
Only an authorized service centre should repair the machine.
Problem
Check
Fuel at the
carburetor
The engine
stalls, is
difficult to
start or does
not start
Fuel at the
cylinder
Sparks at
the spark
GB
Fig.22
Condition
The fuel does not arrive
at the carburetor
The fuel does not arrive
at the cylinder
There is fuel in the
exhaust
There is no spark
30 / 31
Cause
Solution
Fuel filter
Clean or replace
blocked
Fuel supply
Clean or replace
blocked
Ask your distributor for
Carburetor
advice
Ask your distributor for
Carburetor
advice
Open the throttle valve
Clean or replace the air
The fuel mixture
filter
is too rich
Ask your distributor for
advice
Switch in "O"
Set the switch to the ON
position
position (Run)
Publicité
