Publicité
Les langues disponibles
Les langues disponibles
climb out or kick out. The blade may either jump toward or away from the operator,
depending on direction of the blade's movement at the point of pinching.
Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below.
a) Maintain a firm grip on the tool and position your body and arm to allow you to
resist kick back forces.
b) Never place your hand near the rotating accessory. Accessory may kick back over
your hand.
c) Use special care when working corners, sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control or kickback.
Extending the cutting line
WARNING: Do not use any kind of metal wire or metal wire encased in plastic in the
cutting head. This may cause serious injuries to the user.
To extend the cutting line run the motor at full speed and tap the cutting head on the
ground. This will automatically extend the line. The cord cutter under the outer guard will
cut the line to the appropriate length. (fig.20)
Stopping the engine
1. Reduce the throttle trigger and let it run idling for a few minutes.
2. Switch off the engine by moving the engine switch to the stop position.
The cutting attachment may cause an accident if it continues to turn after the engine has
stopped or after the engine switch has been released. When the unit has stopped, check
carefully that the cutting attachment has stopped turning before putting the unit down.
GB
Fig.20
25 / 31
Publicité
