Publicité
Les langues disponibles
Les langues disponibles
GB
Fig.3-1
Fig.3-2
WARNING!
1. When using the cutting line head, the additional guard with line cutting knife,
must always be fitted. (Fig.3-3,Fig.3-4)
Secure the additional guard (26) using the screw (B). (Fig.3-3)
16
Fig.3-3
WARNING!
Please check the blade and output shaft after each adjustment or assembly, it must be
correctly assembled and running smoothly.
Wear protective gloves when handling the guard.
Fitting 3T blade
Take the outer flange off after release the nut, then put the blade, outer flange, shield and
nut according to priority as below picture. Note the blade rotation direction needs be
same as below picture. Use screw driver to hold flange and tighten nut counter-clockwise,
ensure the nut is tightened enough.
.
Fig.4.1
15 / 31
Publicité
