Publicité
Les langues disponibles
Les langues disponibles
4) Slowly pull the recoil starter until you feel it engage and then pull it quickly. till it
starts.( (fig.15)
Attention: Check and make sure cutting attachment always stops when the engine
is idling.
Note: when the engine is started for the first time. It will require a number of
attempts to start until the fuel travelled from the tank to the motor.
5) Turn the choke lever to the run position as the engine started.(Fig.16)
6) After starting the engine, let the engine run for 2 to 3 minutes so that it warms up
before subjecting it to any load.
7) Hot start: When the machine is hot, stays the choke level in "Start position", the user
can start the machine by repeating steps of 1,2,4.
Under the following conditions the machine must be stopped:
1. When the motor rotary speed changes
2. When sparks occur
3. When blade are damaged
4. In case of misfire
5. In case of high vibration
6. When flames or smoke appear
7. In rain or stormy weather
WARNING!
Check the cutting attachment always stops when the engine is idling.
GB
Fig.15
Fig.16
21 / 31
Publicité
