Publicité
Les langues disponibles
Les langues disponibles
GB
Fitting 8T blade
Take the outer flange off after release the nut, then put the blade, outer flange, shield and
nut according to priority as below picture. Note the blade rotation direction needs be
same as below picture. Use screw driver to hold flange and tighten nut counter-clockwise,
ensure the nut is tightened enough.
Fig.4.2
Release blade (Fig.5)
Use screw driver to hold flange and release nut, the blade can be took off.
Fig.5-1
Fig.5-2
WARNING!
Please make sure the cutting head has been assembled correctly before use!
Nylon head
Release the nut(Fig.6)
Line up the two holes of flange and shield, use one screw driver to hold the flange as
below and turn the socket wrench clockwise, the nut will be released.
Fig.6
16 / 31
Publicité
