Publicité
Les langues disponibles
Les langues disponibles
Spark plug
RECOMMENDED SPARK PLUG: A5RTC
To ensure proper engine operation, the spark plug must be properly gapped and free of
deposits.
1. Remove the spark plug cap.
2. Clean any dirt around the spark plug base.
3. Use the socket spanner which provided to remove the spark plug.
4. Visually inspect the spark plug. Remove carbon deposits using a wire brush.
5. Check for discoloration on the top of the spark plug. The standard color should be a tan
color.
6. Check the spark plug gap. The acceptable gap should be between 0,6~0,7mm.
7. Install /reinstall the spark plug carefully by hand.
8. Once the spark plug has been seated, tighten it with a socket spanner.
9. Reinstall the spark plug cap on top of the spark plug.
Cleaning
1. Keep your machine clean, the outside of the machine can be cleaned using a damp
soft cloth with a mild detergent if required, never use water to clean the machine as it
may cause damage to internal parts.
2. Some maintenance products and solvents may damage the plastic parts, these
include products containing benzene. Trichloroethylene, chloride and ammonia.
3. Take special care to keep the ventilation inlets /outlets free from obstruction. Cleaning
with a soft brush followed by a compressed air jet will usually be sufficient to ensure
acceptable internal cleanliness.
4. Empty the oil tank.
5. Wear eye protection when carrying out cleaning.
Empty the fuel and oil
1. Screw off the fuel tank cap.
2. Pour fuel into an appropriate container thoroughly.
3. Press the fuel pump several times to pump the residual fuel into fuel tank.
4. Pour fuel again.
5. Place the machine on even and stable surface.
GB
29 / 31
Publicité
