AVG AVT-309CS-TEXAS Instructions D'installation Et Guide De L'usager page 21

INSTALLING THE MOUNTING BRACKET
WARNING
:
WHEN CUTTING OR DRILLING INTO WALL, DO NOT DAMAGE ELECTRICAL WIRING AND OTHER HIDDEN UTILITIES. WHEN
BUILDING FRAMEWORK, ALWAYS FOLLOW ALL APPLICABLE CONSTRUCTION CODES AND STANDARDS.
 To construct wood wall framing that is flush with surface of wall studs, ensure that:
a) The framing is centered over installation location and is sturdy enough to support the weight of
the hood.
b) The height of the framing will allow the mounting bracket to be secured to the framing within
the dimensions shown.
 After wall surface is finished, carefully center and level the hood mounting bracket, secure it to wall
framing with three 4 x 16 mm mounting screws (that are provided). Tighten the screws completely.
IMPORTANT: Make sure that holes locations are leveled and correctly centered by the vertical centerline (this
installation instruction applies also for concrete walls).
WARNING: TWO PEOPLE ARE REQUIRED TO LIFT AND POSITION THE HOOD ONTO THE MOUNTING SCREWS.
INSTALL UPPER CHIMNEY MOUNTING BRACKET
 Center the bracket over the hood location and place it flush with the wall.
 Make sure that the slots of the upper chimney are properly installed
horizontally .
 Use the upper chimney mounting bracket as a template to mark the position
of its screws.
 Drill both screw holes using a 5/16" drill bit. Insert the drywall anchors
(included) into the drilled holes (one per hole).
 Secure the upper chimney bracket to the wall using two 4 x 16 mm mounting
screws. Make sure that the bracket is tight against the wall.
WARNING: BE CAREFUL WHEN INSTALLING THE DECORATIVE CHIMNEY AND HOOD, THEY MAY HAVE SHARP
EDGES. WE RECOMMEND THAT YOU WEAR PROTECTIVE GLOVES.
CAUTION: DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE DECORATIVE CHIMNEY AT THIS
STAGE.
21