Hach AMTAX sc Mode D'emploi page 5

Section 5
5.1 Sensor diagnostics menu
SELECT AMTAX sc (if more than one sensor or analyzer is attached)
AMTAX sc
Error list
Warning list
5.2 Sensor setup menu
SELECT AMTAX sc (if more than one sensor or analyzer is attached)
CALIBRATION
Correction factor
Location 1
Gain correction
Location2
Gain correction
Calibration
Calibration & cleaning
Settings
Calibration output mode
Automatic calibration
Interval
Start
Discarded
measurements
Adjustment method
Advanced
Basic
Reset
Settings
Location 1
Name
Parameter
Unit
Settings (continued)
Operation All manuals and user guides at all-guides.com
The AMTAX sc can only be operated with an sc1500 controller. For
further information, see the sc1500 User Manual.
An LED on the door indicates the current operating state.
Instrument, chemicals and electrode are temperature-sensitive. To
prevent incorrect measurements, only operate the instrument with
the door closed.
Displays all errors currently present in the sensor
Displays all warnings currently present in the sensor
Displays the correction factor
Displays location1 which is adjusted in the CONFIGURE menu
Adjusts the correction factor for channel 1
Available with the 2-channel version.
Available with the 2-channel version.
Triggers an automatic calibration, then measuring mode
Triggers an automatic calibration with subsequent automatic cleaning, then measuring mode.
Value that is output during a calibration and the following discarded values.
Hold = last measured value, Transfer = value to be entered.
Time interval between two calibrations
Start time for the calibration (In case of more than one calibration per day: Enter start time for
the first calibration.)
Number of measured values that are discarded after a calibration.
Select the calibration method
Default calibration method for software version ≥ 1.60 (For best accuracy with lowest
measuring values.)
Calibration method for software version < 1.60 is available for compatiblility reasons (Not
selectable in the measuring range 0.02–5 mg/L.).
Resets to factory default settings.
Settings for location 1
Enter the name for the measuring location as required.
Select output: ammonium or ammonium nitrogen
Select output: mg/L or ppm
English
5