Publicité
Les langues disponibles
Les langues disponibles
This function has two performances:
Method 1:
The door remains open longer than the set period of time (01 to 99
seconds).
In this case the buzzer sounds a constant signal tone to remind you
to close the door. As soon as the door is closed the signal tone
stops.
Method 2:
If the door is forced open - the buzzer sounds as an alarm signal -
even if the door is closed again, the signal tone continues to sound
from the buzzer. The alarm can only be deactivated using a valid ID
card, by entering a valid code or with a valid card + valid user number.
Factory setting is "9-00".
9. Code Lock Operation
9.1 Standby Mode
The code lock is in standby mode as long as it is not currently in programming mode.
While the code lock is in standby mode the yellow "STATUS" LED (3) blinks at 2 second
intervals.
9.2 Activating Relay Output 1 "OUTPUT 1" (F)
Please note that this step is dependent on the input method you
selected in Chapter "8.11 Function Settings (a - Setting Input
Method) Depending on the setting made, the activation is carried out
either by pushing the # button after the user code or not.
The relay output 1 "OUTPUT 1" (F) can be activated depending on the activation method
selected ( see Chapter: "8.6 Assigning the Activation Method for "OUTPUT 1"):
All manuals and user guides at all-guides.com
53
Publicité
