Conrad 75 15 49 Notice D'emploi page 50

Example delete user code:
52 5648
c) Deleting User Codes using the User Number
To delete user codes from "OUTPUT 2" (G) using the corresponding user number, enter
the following key combination:
53 Enter the user number of the user code to be deleted
Example delete user code using user number:
53 894
8.10 Programming the Timer and the Activation Method for
"OUTPUT 2"
To carry out this programming step the code lock should now be in
programming mode (see Chapter "8.1 Entering Programming
Mode").
You can programme whether the relay output 2 "OUTPUT 2" (G) is activated only for a
specific period of time (01-99 seconds) or whether it should be blocked.
a) To assign an activation time for activation of the relay output 2 "OUTPUT 2" (G)
enter the following key combination:
60 Time in seconds
(you can programme from 01 to 99 seconds)
Example for 86 second activation time:
60 86 #
The factory setting is a 3 second activation time.
b) To block the relay output 2 "OUTPUT 2" (G) enter the following key combination:
61 #
48
All manuals and user guides at all-guides.com
#
#
#
#