Conrad 75 15 49 Notice D'emploi page 46

1 4 digit user number
Example:
1 1112
8.5.3 Programming User Code to "OUTPUT 1" (F)
To carry out this programming step the code lock should now be in
programming mode (see Chapter "8.1 Entering Programming Mode").
To programme a user code to the relay output "OUTPUT 1" (F) enter the following key
combination:
1 4 digit user number
Example:
1 1112
Saving user codes
On the keypad (7) press the key "1" and now enter a 4-digit user number and a 4 to 8-dig-
it user code. Press the "number" key "#" - the green LED (4) blinks. Press the "number"
key "#" again and the green LED (4) stops blinking. Your entry is confirmed.
If you want to save several codes, you do not have to press the
"number" key "#" again after the second time. Save the individual
codes as described above and press the "number" key "#" after the
last entry. This saves all previous entries as well.
Input:
"1" --- "4-digit user number" --- "4 to 8-digit user code" --- "#" --- "#"
8.5.4 Deleting ID Cards or User Codes from "OUTPUT 1" (F)
To carry out this programming step the code lock should now be in
programming mode (see Chapter "8.1 Entering Programming
Mode").
44
All manuals and user guides at all-guides.com
Now hold the ID card up to the
"card reader" (5).
The card to be programmed in is
held up to the "card reader" (5)
4-8 digit user code
9876
#
#
#
#