Conrad 75 15 49 Notice D'emploi page 45

8.5 Assigning ID Cards and User Codes to OUTPUT 1
8.5.1 What is a User Number
If you wish to programme an ID card or a user code to activate the relay output "OUTPUT
1" (F), you must always assign a user number to that card or code.
A user number is a number under which the ID card and/or the user code is saved.
In order to make clear the connection between the user number, ID card and user code, the
following example table provides a list of 7 programmed user numbers.
User number
1111
1112
1113
1114
1115
1116
A user number is thus nothing other than a memory location under which you must save
ID card and/or the user code.
Note that the user numbers for "OUTPUT 1" (F) must be 4 digits long
and those for "OUTPUT 2" (G) must be 3 digits. The user code must
always be 4-8 digits long.
User numbers cannot be assigned twice.
8.5.2 Programming ID Cards to "OUTPUT 1" (F)
To carry out this programming step the code lock should now be in
programming mode (see Chapter "8.1 Entering Programming
Mode").
To programme an ID Card to the relay output "OUTPUT 1" (F) enter the following key
combination:
All manuals and user guides at all-guides.com
ID card
ID card 1
ID card 2
ID card 3
Usercode
9876
4289
8946
43