Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLATION INSTRUCTIONS
TOOLS NEEDED TO INSTALL THE RANGE HOOD
▪
Phillips screwdriver
▪
Hammer and flat blade screwdriver
▪
Sheet metal sheers
▪
Pair of pliers
▪
Scissors (to cut duct tape)
▪
Metal foil duct tape
▪
Marker or pencil
▪
Level
▪
Measuring tape
BEFORE INSTALLING THE HOOD
▪
For the most efficient airflow exhaust, use a straight run or as few elbows as possible.
▪
Vent unit to the outside only.
▪
Two (2) people are required for installation.
▪
Remove the range hood from the carton packaging and place it on a flat surface for assembly.
ELECTRICAL REQUIREMENTS
CAUTION: THIS APPLIANCE SHOULD BE PROPERLY GROUNDED.
▪
This hood must be power supplied from a 110-120 V, 60 Hz source and connected to an
individual, properly grounded circuit (3-prong outlet).
▪
If the electrical supply does not meet above requirements, call a licensed electrician before
proceeding.
▪
Route house wiring as close as possible to the installation location, in the ceiling or back wall.
▪
The hood must be connected to the house wiring in accordance with the local codes and
norms.
WALL FRAMING FOR ADEQUATE SUPPORT
This vent hood is heavy. Adequate structure and support must be provided in all types of
installations. If mounting on dry wall, the hood must be secured to vertical studs in the wall or to
a horizontal support.
19
Publicité
