ROBBE SZD 54 Manuel D'utilisation page 15

F L I G H T I N S T R U C T I O N S
• Before the first flight, observe the instructions in the „Safety Instructions" section.
• When flying the model, you should choose a day with as little wind as possible
• A large, flat area without obstacles (trees, fences power lines etc.) is suitable for the first flights.
• Please carry out a functional test of the drive train / power set and remote control.
• After assembling the model on the airfield, check once again that all model components such as
wing, tail units, wing mounts, engine, linkages, etc. are firmly and properly fastened.
• For a hand start a helper should be present, who can throw the model with enough thrust into the
air.
• The start usually takes place against the wind.
• Do not stall the model near the ground
• Do not initiate tight turns in the immediate vicinity of the ground.
• Check the reactions of the model to the rudder deflections. If necessary, adjust after landing to
increase or decrease the deflections accordingly.
• The minimum flight speed must be at an adequate safety altitude.
• Initiate the landing with sufficient speed
S A F E T Y I N S T R U C T I O N S F O R R E C H A R G E A B L E B A T T E R I E S
• Do not immerse the battery in water or other liquids.
• Do not heat, throw into fire or microwave.
• Do not short-circuit or charge with reversed polarity
• Do not expose, deform or throw the battery
• Do not solder directly on the battery
• Do not change or open the battery
• Only charge the battery with suitable chargers, never connect it directly to a power supply unit.
• Never charge or discharge the battery or charger on a flammable surface.
• Never leave the battery unattended during charging or discharging processes.
• Never charge or discharge the battery in direct sunlight or near heaters or fire.
• Do not use the battery in places subject to high static discharge.
All this can cause the battery to be damaged, explode or even catch fire!
• Keep the battery away from children
• Keep leaked electrolyte away from fire, as it is highly flammable and may ignite.
• The electrolyte liquid should not get into the eyes, if it does, rinse immediately with plenty of clear
water and then see a doctor.
• The electrolyte liquid can also escape from clothes and other objects with a lot of water or was-
hed off.
• Observe the safety instructions of the battery manufacturer and the charger manufacturer.
Thank you for purchasing the ROBBE „SZD-54". The model is a modern moulded foam model, largely
assembled, with a wide range of applications.
I N S T R U C T I O N S A N D U S E R M A N U A L
P R E F A C E
T E C H N I C A L D A T A
Span
approx. 2120 mm
Length approx. 1017 mm
Flying weight
approx. 1150 g
C.G.
60 mm behind the leading edge
B O X C O N T E N T
1. Fuselage 4. Rudder
2. Wingset 5. Attachment parts, surface connectors, Y-cables, screws
3. Elevator 6. Winglets / 2 different versions
Elevator
yes
Rudder yes
Ailerons
yes
Flaps
no
Landing flaps no
Motor
yes
15