Magmaweld monoMIG 200ik Mode D'emploi page 19

monoMIG 200ik
• After placing the reels to be used, tighten the screws, lower the thrust bearings, and lift the thrust bearing
lever and lock it on the thrust bearings.
Figure 8 : Removing Wire Feed Reels
3.5 Placing the Wire Spool and Wire Feeding Process
• Unscrew the wire holder system screw. Insert the welding wire reel to the wire transport system shaft and
re-screw the screw.
c
b
a
• Pull down on the thrust bearing arm on the wire feed reel, which means setting thrust bearing free.
Figure 10 : Placing Wire Basket
• Remove the welding wire from the wire basket, hold the wire tightly and cut the end with
diagonal pliers.
When the wire slips from your hands, the wire may hurt you or other people in the vicinity.
• Hold the wire tightly and pass it through the wire inlet to the reels and over the rollers into the torch.
Figure 11 : Feeding Wire to Reel
www.magmaweld.com
Tightening the wire transport system screw too tightly may prevent
the wire from feeding and cause malfunctions. Tightening the screw
too loose may cause the wire basket to move freely and wire to get
kinked when the wire feed is stopped. Therefore, tighten the screw
neither too tight nor too loose.
Figure 9 : Placing Wire Feed Reels
Operation 19
EN
USER MANUAL