Faber GALILEO BK GLASS NG A830 Manuel D'utilisation page 13

selected level. The period of time the cooking
area will remain at maximum power depends on
the final cooking level that is set. See table:
Lev. Power
1
2
3
4
5
6
7
8
9
P
To activate, with a pan on the hob and selected
cooking area, press and hold for 3 seconds on the
selected value (from 1 to 8) on the power bar. The
Display for the corresponding area shows " A " .
It is possible to increase the cooking level, but if it
is decreased the function is deactivated.
It can also be deactivated by pressing and hol-
ding for 3 seconds the button for the cooking area
in question.
Error code
ER 03 and Continuous sensor
continuous tone activation; TC turn off
after 10 sec
ER20 Flash memory – TC error
ER22 Button evaluation
defective, UI shuts off
after 3.5-7.5 sec
ER31
Incorrect configuration
data or deviation between
generator and TC
ER36 NTC value defective on
TC; UI turns off
ER47 Communication error
between TC and induction
U400 Continuous tone Power
supply on inlet to high
E/2
Excess temperature of
the induction element
E/A
Error on the power board
E/6 Error on power board
E/8 Incorrect fan speed
E/9 Defective temperature
sensor on inductor
Time
48 seconds
144 seconds
230 seconds
312 seconds
408 seconds
120 seconds
168 seconds
216 seconds
not available
not available
Error codes
Description
Water or cookware on the glass
over the touch control sensors
μC- defective
Short or open circuit in the area
of the button sensoric
New configuration of the
induction generator required
Short or open circuit of NTC
No or erroneous LIN
communication! (Slave does not
answer to request of master)
Incorrect connection of the
cooktop
Overload of cooktop or empty
boiled cookware
Component failure
No power supply or error on
power board
Error on fan left or right
MODEL
Max Total Power
Possible cause of error
GALILEO BK GLASS
NG A830
7,620 kW
Remedy
Clean the control surface,
remove objects on the
sensors.
Replace TC
Replace TC
New configuration (Service
menu)
Replace TC
Connection cable not correctly
plugged in or defective.
Correct power supply
connection
Let system cool down.
Replace power board
1. check wiring
2. check filter board
3. replace power board
Air exhaust blocked, e.g. by
paper Replace Defective fan
Replace inductor Replace
power board
13