Trumpf S 420-0 Mode D'emploi page 16

Wearing parts
S420
Moving cutter blade for 1-3 mm
(type marking "3")
Moving cutter blade for 3-4.2 mm
(type marking "4")
Moving cutter blade for high-tensile sheets
(type marking "Cr")
Fixed cutter blade for 1-4.2 mm
Fixed cutter blade for high-tensile sheets
(type marking "Cr")
Original accessories
Accessories delivered with the machine
Description
Tool set (moving cutter blade and fixed cutter blade,
installed)
Handle
Cheesehead screw M8x20
to fasten the handle
Allan key
Allan key
Allan key
Grinding gauge
Operating manual
Safety instructions (red print)
Optional
Traction eyelet
Hook
Coil casing, complete (incl. traction eyelet)
Case
16
GB
All manuals and user guides at all-guides.com
Order no.
106149
103496
107623
103498
107621
Order no.
094664
DIN 912 016012
DIN 911-6 067865
DIN 911-5 067857
DIN 911-2.5 067822
106577
104853
125699
Order no.
107668
097208
124015
121585
S 420 - 0
Ordering spare parts and wearing
parts
Please proceeds as described below in order to
prevent delays and incorrect deliveries:
• Copy the page found opposite the replacement
part figure as "Order form for replacement parts
and wearing parts"
• Complete this form by stating
the manufacturing No.
-
the voltage, when ordering electrical parts
-
your exact address in the "Dispatch address"
-
space
the desired amount of parts in the "Parts"
-
column
the desired mode of dispatch (e.g. air mail,
-
special delivery, express, cargo, parcel-post,
etc.) in the line with the
• Should you wish to order wearing parts, write this
in the empty space at the end of the order form. To
differentiate between various tool types, please
observe the chapter "Wearing Parts."
• Send the completed form (per fax) to your
TRUMPF representative.
You will find a list of TRUMPF
representatives at the back of this operating
Warranty
TRUMPF electric and pneumatic tools are guaranteed
for a period of 6 months after the date of purchase.
Damage caused by normal wear, excessive strain or
improper use is excluded from the warranty.
Damage caused by poor workmanship or defective
material shall be repaired or replaced at no charge.
Claims shall only be accepted if the unit is sent to a
TRUMPF representative.
Notes on documentation
The document was
Documentation department of TRUMPF GmbH + Co.
All rights reserved, particularly those concerning the
duplication, distribution
documentation, even in the event of property right
registration.
 TRUMPF GmbH + Co.
symbol
manual.
written by the Technical
and translation of
E251.doc
this