Napoleon Acies Serie Manuel D'installation page 54

finishing
EN
11.9 glass media installation / removal
WARNING
!
• Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
• Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your local authorized dealer / distributor.
• Glass media over the burner ports will cause flame lifting and sooting problems. Adjust as necessary.
• Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Evenly spread the glass media onto the media tray. Ensure no glass media falls into the pilot opening. If this
happens, insert a clean bag into your vacuum cleaner and vacuum out the glass media. Replacement glass can
be purchased from your local dealer / distributor.
Cleaning Glass Media
Glass media may have a fine oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
Removing Media
Using a vacuum cleaner, use a clean bag and vacuum out the glass media.
note:
If media trays (optional) are not required, remove and install glass media for best flame and LED appearance.
note:
Do not place media directly over peaks (see "flame characteristics" section for more information).
54
W415-1707 / B / 06.04.18
All manuals and user guides at all-guides.com
note:
Do not use more media than what was supplied with the appliance.
Do not place media directly onto the burner or pilot opening.
Pilot Area