11.5 TV mounting restrictions
Flush installation without mantel
Enclosure
Top of
finishing
flange
(fireplace
Appliance
opening)
Recessed installation with protrusion
6" min.
2.5" min.
2" min. (3" max. recommended)
Enclosure
Appliance
note:
•
These are recommended minimum clearances only and are in supplied in good faith. They are not a
guarantee of compliance with TV manufacturers' maximum allowable operating temperatures. Always
comply with TV manufacturers' requirements.
•
TV temperatures must be validated at the time of installation as air flow characteristics within the
room can vary and maximum acceptable operating temperatures can vary from appliance to appliance.
TVs cannot be used where the TV temperature exceeds the manufacturer's maximum allowable operating
temperatures (see TV manufacturer's specifications).
•
Mantel height and depth must conform to mantel clearance requirements specified in this manual (see
"minimum clearance to combustible mantel" section).
•
Dimension "A", the gap between the top of the finishing flange and the bottom of the TV, is taken from the
top of the fireplace opening.
•
TV temperatures may be further reduced by increasing the horizontal distance between the front of the TV
and the front edge of the mantel or by increasing dimension "A"; however, increasing the gap between the
top of the mantel and the bottom of the TV beyond the maximum recommended figure typically results in
higher temperatures. Minimum clearance between the mantel and bottom of the TV should be maintained to
allow air circulation.
All manuals and user guides at all-guides.com
TV bracket
TV bracket
Top of finishing flange
(fireplace opening)
See "minimum clearance
to mantle" section
A
(installation manual).
Partially recessed installation with mantel
6" min.
TV bracket
2.5" min.
2" min. (3" max. recommended)
A
Enclosure
Top of finishing flange
(fireplace opening)
Appliance
Flush installation with mantel
6" min.
TV bracket
2.5" min.
2" min. (3" max. recommended)
A
Enclosure
Top of finishing flange
(fireplace opening)
Appliance
finishing
EN
51
W415-1707 / B / 06.04.18