Napoleon Acies Serie Manuel D'installation page 50

finishing
EN
11.4 minimum combustible mantel clearances
WARNING
!
• Risk of fire. Maintain all specified air space clearances to combustibles. Failure to comply with these
instructions may cause a fire or cause the appliance to overheat. Ensure all clearances (i.e. back, side, top,
vent, mantel, front, etc.) are clearly maintained.
• When using paint or lacquer to finish the mantel, the paint or lacquer must be heat resistant to prevent
discolouration.
• Installing a television or other electronics above the appliance may cause discolouration, melting, or damage
to the electronics. Use clearances as guidelines and refer to your TV manufacturer's instructions for further
information.
Combustible mantel clearance can vary according to the mantel depth. Use the graph to determine the clearance
needed.
24
22
20
18
M H
16
A E
14
N I
12
T G
10
E H
8
L T
6
4
2
0
1 2 3 4 5 6 7 8 9 10 11
MANTEL DEPTH
Installing a mantel between this appliance and electronics or other materials that may be sensitive to heat will
reduce the effect of direct heat on them.
Follow mantel height restrictions for proper clearance according to the depth of the mantel.
A non-combustible mantel is considered a non-combustible protrusion, see "finishing" for protrusion restrictions.
50
W415-1707 / B / 06.04.18
All manuals and user guides at all-guides.com
E
D
C B
A
Optional hearth
extension (no
depth restriction)
MANTEL DEPTH
note:
Min. height is 18" (45.7cm) for
a 2" (50mm) protrusion as a
starting point.
MANTEL HEIGHT
Top of
finishing
flange
Bottom of
25 11/16" (65.2cm)
A
finishing
2"
Bottom of the
appliance
flange