Foppapedretti TicToc Notice D'utilisation page 35

THE STROLLER CAN BE WHEELED ALONG LUGGAGE-STYLE WHEN CLOSED (fig. 59)
Pull the stroller backwards to turn the front wheels lengthwise.
Adjust the handlebar to its widest position, see paragraph "Adjusting the handlebar".
Fold up the stroller, see paragraph "Stroller closure".
USING THE TRAVEL SYSTEM ACCESSORIES
The TicToc pushchair can be used with the following travel system accessories, TicToc carrycot and TicToc infant car seat.
Remove the seat from the chassis (see the paragraph "Fitting the seat").
Engage the stroller parking brake (fig. 34).
USING THE INFANT CAR SEAT AND CARRYCOT TRAVEL SYSTEM ACCESSORIES (fig. 60, 61)
IMPORTANT: the travel system accessories must be secured to the chassis only in the parent facing.
CARRYCOT - EN 1466:2014 + AC:2015
ASSEMBLING THE FRAME
Lift up the handle, a click will indicate that it is locked in the vertical position. Make sure that it is locked.
•
Press the bottom of the carrycot downwards to raise the sides of the carrycot.
•
Open the ZIP on the side (fig. 62).
•
Pull the frame support brackets towards the outside of the carrycot, using the straps, until they lock into the 4 clips.
•
Make sure that the brackets are locked into the 4 clips (fig. 63, 64).
•
Fold the fabric, attach the velcro as shown in the figure, secure on the side with the ZIP. Make sure that the fabric is
•
properly secured with the zip and that there are no openings along the side (fig. 65).
Place the mattress inside the carrycot (fig. 66).
•
ADJUSTING THE HANDLE/HOOD
Press the side buttons and adjust the handle to the new position, release the buttons and make sure that it is locked
(fig.67, 68).
COVER
Fix the cover along the sides, attach the flaps with the Velcro (fig. 69).
Lift up the front fabric flap of the cover for added protection, attach the press studs (fig. 70).
CLOSING THE CARRYCOT
Remove the cover (fig. 71);
•
Place the handle in a horizontal position (fig. 72);
•
Take out the inner mattress (fig. 50);
•
Open the ZIP on the side and lift up the fabric along the side on the inside (fig. 74);
•
Grasp the belt and, pulling towards the inside of the carrycot, release the support bracket from the clips and close it
•
towards the inside of the carrycot. Repeat this process also on the second support bracket (fig. 75, 76).
Fold the bottom of the carrycot upwards (fig. 77);
•
Insert the mattress inside the carrycot;
•
Place the cover on the frame and attach the flaps with the Velcro along the sides (fig. 78).
•
CARRYCOT COMPONENT
Fitting the accessory: Align the coupling device of the carrycot and press downwards, a click will indicate that the carrycot
has attached correctly to the stroller frame. Make sure that the accessory has been fastened correctly on both sides.
(fig. 79).
WARNING: Before use, always make sure that the accessory has been secured correctly. When the accessory is lifted
upwards it must not detach from the pushchair chassis.
Removal of carrycot: PRESS the buttons "a", on both sides, and remove the carrycot by lifting it up using the handle (fig.
81, 82).
• ENGLISH •
USE
35