Migatronic PI 250 DC HP Manuel D'instruction page 19

Dynamic Oxide Control
(for AC welding).
0 = disabled
1 = enabled (default setting)
Torch Remote Control
Makes it possible to control how the
control unit on the handle is used when torch
adjustment is enabled (
0 = Setting the current reference (factory
default).
1 = Enabling/disabling TIG-A-Tack
(the TIG-A-Tack button is disabled).
The control unit is handled as follows:
Steps 1-3: TIG-A-Tack is
Steps 4-7: The trigger is
Steps 8-10: TIG-A-Tack is
2 = Up/Down module
Trigger
Enabling/Disabling
TIG-A-Tack
* Keep pressed for
constant increase/reduction
All above settings are not modified via Reset.
).
enabled
disabled
disabled
Trigger
19