Midea MP10SCWBA2RCM Manuel Utilisateur page 20

Other Features
FOLLOW ME/TEMP SENSING Feature (Optional)
NOTE: This feature can be activated from the remote controller ONLY. The remote
controller serves as a remote thermostat allowing for precise temperature control
at its location.To activate the "Follow Me/Temp Sensing" feature, point the remote
controller towards the unit and press the "Follow Me/Temp Sensing" button. The
remote controller displays the actual temperature at its location. The remote
controller will send this signal to the air conditioner at 3-minute intervals until the
"Follow Me/Temp Sensing" button is pressed again. If the unit does not receive the
"Follow Me/Temp Sensing" signal within a 7-minute interval, the unit will beep to
indicate the end of the "Follow Me/Temp Sensing" mode.
AUTO-RESTART
If the unit breaks off unexpectedly due to power outage,it will automatically restart with the previous
function settings when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, do not restart in the first 3 minutes. This is to
protect the unit. Operation will automatically resume after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the
air flow direction automatically (NOTE: The louver on some models
can be only adjusted manually):
-When the power is ON, the louver opens fully.
-Press the SWING button on the panel or remote
controller to initiate the Auto swing feature. The
louver willl swing up and down automatically.
-Please do not adjust the louver manually.
Water Drainage
-During dehumidifying modes, remove the upper drain
plug from the back of the unit and install the drain
connector (5/8" universal female mender) with a 3/4"
hose (locally purchased). For models without a drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement floor.
Operation
Remove the
upper drain plug
Continuous
drain hose
19
√
SCALE 0.500