Midea MP10SCWBA2RCM Manuel Utilisateur page 15

Step 3: Preparing the
Adjustable Window Slider
1. Depending on the size of your window,
adjust the size of the window slider.
2. If the length of the window requires two
window sliders, use the bolt to fasten the
window sliders once they are adjusted to
the proper length.
Note: Once the exhaust eose assembly and adjustable window slider are prepared,
choose from one of the following installation methods.
Type 1: Hung Window Installation
Foam seal B
(shorter adhesive type)
Cut the adhesive foam seal
A and B strips to the proper
lengths and attach them to
the window sash and frame
as shown.
Security bracket
2 screws
If desired, install the
security bracket with
2 screws as shown.
Installation
Foam seal A
(adhesive type)
Insert the window slider
assembly into the window
opening.
Insert the window slider
adaptor into the hole of
the window slider.
Window slider A
Window slider B
Window slider A
(if required)
14
Bolt
Window slider B
Foam seal C
(non-adhesive type)
Cut the non-adhesive foam
seal C strip to match the width
of the window. Insert the seal
between the glass and the
window frame to prevent
air and insects from getting into
the room.